"WINCO" QUALITY POLICY

All blocks are designed and machined to ISO standards. Material specification confirms to Cast Iron of IS210 grade FG260, Cast Steel of IS 1030 grade 43/58,S.G.IRON of IS 1865 grade 400/12.

Bearing seat of the housing is machined with H7 housing fit and sufficiently wide to enable the bearing to be displaced axially.Located bearing mounting are obtained by inserting suitable Locating Rings. They are then designated fixed type bearing mountings, floating bearings are without locating rings and fixed type are with locating rings.

Sealing of housing is done by felt seals or triple labyrinth seals on both inch and metric shafts. For labyrinth seals 'O' ring cords ensure that the labyrinth seals which are mounted with loose fit rotate with the shaft.

Grease Nipple and Drain Plug are provided for grease and oil lubrication.

Housing with felt seals are designated T.C. and housing with labyrinth seals are designated T.S.

Metallic End Plates are provided for closed shaft ends. Eye Boalts are provided depending upon the load and design of the block.

Material are shot blasted and given primer treatment with outer surfaces of "WINCO" housing which are unmachined provided with universal coat of synthetic paints.

RANGES OF "WINCO" PLUMMER BLOCKS.

1. SN 5,6 & 2,3 SERIES.  7.   T.V.N. 2,3 SERIES
2. F/SAF 5,6 &2,3 SERIES  8.   FLANGE BLOCKS
3. S-30K SERIES  9.   PILLOW BLOCKS
4. SD 5,6 & 31 SERIES 10.  HANGER BLOCKS AND TAKE-UP BLOCKS
5. SDAF 5,6 &2,3 SERIES 11.  SPECIAL TYPES BEARING HOUSINGS
6. F- SERIES BLOCKS  


ORDERING of "WINCO" PLUMMER BLOCKS HOUSINGS.

Technical "FIT" to be provided.

  1. Material specification.
  2. Housing design number along with bearing size and shaft diameter
  3. Type of bearing mounting( fixed type or float type) for the supply of  locating rings.
  4. Type of mounting between shaft and bearing (Adaptor/Straight).
  5. Type of shafts Closed end shafts or Open end shafts.
  6. Type of seals felt seals or labyrinth seals.
  7. Type of lubrication Oil lubrication 'or' Grease lubrication.
  8. Quantity of your ordering blocks.

Commercial "FIT"

: Negotiable Prices and delivery with other terms will be communicated on receipt of Technical "FIT".

Your Enquiry

Contact Person : D.KAPUR   C.E.O.                            


ASHOKA BEARING HOUSING PRIVATE LIMITED.
P.O. Box 5860 , 46B, II PHASE ,
Peenya Industrial Area.
BANGALORE-560058.
KARNATAKA. INDIA
Phone : 091+080-28394193, 28378062.
Fax : 091+080-28394193
e-mail : abh@wincoplummerblock.com

» About us » Quality Policy » Enquiry Products » WINCO - A » WINCO - B » WINCO - C » Home
Copyright © 2000-2001 ABH LTD. All rights reserved